O P E R A T E M 1 9 P E R I S C O P E

O P E R A T E M 1 9 P E R I S C O P E (cont) - TM-9-2350-261-10_315

TM-9-2350-261-10 Recovery Vehicle Full Tracked: Medium M88A1 NSN 2350-00-122-6826 Winch Power Takeoff and Hoist System Manual
Page Navigation
268

TM 9-2350-261-10 O P E R A T E M 1 9 P E R I S C O P E INITIAL SETUP Personnel Required: Equipment Conditions: Driver M19 periscope installed (page 2-205) WARNING High voltage in the M19 periscope can cause serious injury or death. Voltage could ex- ceed 16,000 volts. To avoid accidents, observe the following: Always connect power cable to periscope before turning MASTER SWITCH and I.R. POWER switch ON. Before disconnecting power cable from M19 periscope, always wait at least two minutes after turning I.R. POWER and MASTER SWITCH OFF. Do not disconnect power cable until image disappears from periscope screen. Never touch end of power cable, or allow it to contact metal surfaces. 1. Remove periscope power cable from stowage receptacle on master switch panel. 2-208

Privacy Statement
Press Release
Contact