TM 9-2350-261-10I N S T A L L / R E M O V E M 1 9 P E R I S C O P E D E S C R I P T I O N This task covers:Install M19 Periscope (page 2-205).Remove M19 Periscope (page 2-207).INITIAL SETUP Personnel Required: Equipment Conditions (cont): DriverDriver’s hatch cover closed(page 2-144)Equipment Conditions: Carrier blocked (page 2-221)Engine stopped (page 2-184)WARNINGHigh voltage inthe M19 periscopecan cause seriousinjury or death.Voltage could ex-ceed 16,000 volts.To avoid accidents, observe thef o l l o w i n g :Always connect power cableto periscope before turningMASTER SWITCH and I.R.POWER switch ON.Before disconnecting powercable from M19 periscope,alwaysw a i t a t l e a s t t wominutes after turning I.R.POWERandMASTERSWITCH OFF.Do not disconnect powercable until image disappearsfrom periscope screen.Never touch end of powercable, or allow it to contactm e t a l s u r f a c e s .INSTALL M19 PERISCOPE 1. Squeeze latches and push up onplug assembly to release plugassembly from quick release. Tiltplug assembly to remove throughopening in quick release.GO TO NEXT PAGE2-205
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business