S T A R T E N G I N E W I T H O U T S I D E P O W E R S O U R CE (cont)

S T A R T E N G I N E W I T H O U T S I D E P O W E R S O U R CE

TM-9-2350-261-10 Recovery Vehicle Full Tracked: Medium M88A1 NSN 2350-00-122-6826 Winch Power Takeoff and Hoist System Manual
Page Navigation
235

TM 9-2350-261-10 WARNING Electrical slave cable can be improperly connected causing electrical spark or fire. Personnel can be killed or injured. Equipment can be damaged. Match connector guide lug and cable prongs with receptacle hole. 4. Connect slave cable to auxiliary power receptacle on disabled carrier. 5. Connect slave cable to auxiliary power receptacle on source carrier. 6. Start engine of source carrier (page 2-161). 6.1. Turn MASTER SWITCH ON in disabled vehicle 7. Run engine on source carrier at a fast idle (1000-1200 rpm)to show charging on BATT GEN indicator. 7.1. Run engine on source carrier at fast idle for 3-5 minutes before starting disabled vehicle. NOTE In cold weather areas, air box heater can be switched on to heat engine on disabled carrier before attempting to start it. 8. Start engine on disabled carrier (page 2-161). WARNING Electric sparking c a n b u r n y ou Equipment can be damaged. Make sure to disconnect slave cable carefully not to cause any sparks. 9. Turn MASTER SWITCH OFF on both carriers. 10. Disconnect slave cable from auxiliary power receptacle on both carriers. 11. Install cap on auxiliary power receptacle on both carriers. 12. Turn MASTER SWITCH ON on both carriers. END OF TASK Change 5 2-175

Privacy Statement
Press Release
Contact