TM 9-2350-261-10
S T A R T E N G I N E W I T H O U T S I D E P O W E R S O U R CE
INITIAL SETUP
Tools:
Slave cable
source carrier
Personnel Required:
Equipment Conditions:
Carrier unable to start under own
power
Source carrier parked alongside of
disabled carrier
Driver (2)
Source carrier engine stopped
(page 2-184)
CAUTION
2. Remove cap from auxiliary power
Do not start vehicle if batteries
receptacle on both carriers.
are frozen.
NOTE
Step 3 should be done if your
carrier is equipped with an M8
alarm system. If you do step 3,
connect leads and install distri-
bution box cover after starting
problem has been corrected.
When starting,
carriers can move
s u d d e n l y a n d
crush personnel.
Personnel should
stay clear of area
between carriers.
3. Remove distribution box cover
and disconnect M182 mount cable
1. Check that MASTER SWITCH is
OFF on both carriers.
leads 509B and 509C before
jump-starting.
2-174
Change 5