TM 9-2350-247-34INSTALL TURN SIGNAL KIT — Continued 0076 00INSPECTION-ACCEPTANCE AND REJECTION CRITERIAINSPECT1. Check brackets, lights, control, and flasher. Look for secure mounting. Make sure all lock washers are installed underscrew heads and nuts, or between brackets for proper grounding of parts.TEST AND INSPECTIONTEST1. Connect battery negative lead(s) (see your -20).2. Turn MASTER SWITCH ON.3. Place main light selector switch in STOP or SER. DRIVE position.4. Move lever control assembly to left. Check left front turn signal light and left rear stoplight-taillight. Control lever light,left front signal light, and left stoplight-taillight should flash intermittently. There should also be 24 volts intermittentlyat pin B of trailer light receptacle. If brakes are applied, left stoplight-taillight should be ON and 24 volts at pin B oftrailer light receptacle.5. Move lever on control assembly to right. Check right front turn signal light and right rear stoplight-taillight. Controllever light, right front turn signal light, and right stoplight-taillight should flash intermittently. There should also be 24volts intermittently at pin B of the trailer light receptacle. If brakes are applied, left stoplight-taillight should be ON and24 volts at pin B of trailer light receptacle.6. Lift stop on lever on control assembly, and move lever to extreme right. Light on control lever, both front turn signallights, and both rear stoplight-taillights should flash intermittently. There should also be 24 volts intermittently at pins Band J of the trailer light receptacle.7. Place main light selector switch in B.O. DRIVE position and infrared blackout selecting switch in B.O. position. Frontblackout marker lights, blackout headlights, and blackout marker lights in taillights should come on. In addition, newright blackout stoplight should come on when both differential steering levers are pulled to brake carrier.PAINT1. Clean and paint all exposed unpainted metal surfaces as needed after final inspection and test in accordance withTM 43-0139.FOLLOW-THROUGH STEPS1. Install cargo compartment floor plates (see your -10).END OF TASK0076 00-26
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
