TM 9-2350-247-34
INSTALL TURN SIGNAL KIT — Continued
0076 00
39. One at a time, remove three terminals (1), sleeves (2), shells (3), and marker bands (4) from ends of circuit 17, 18, and 20
leads of main wiring harness (5). Pull leads from gasket (6). Discard terminals and gasket. Thread leads through new
gasket. Reinstall shells, sleeves, and marker bands on leads.
40. Install three terminals (1) on ends of circuit 17, 18, and 20 leads. Slide sleeves (2) and shells (3) over terminals.
41. Slide gasket (6) into stuffing tube (7). Install nut (8).
42. Connect circuit 17 and 18 leads to right service head lamp (see your -20).
0076 00-16
