TM 9-2350-247-34
REPAIR ENGINE AND TRANSMISSION STAND (M548A3) — Continued
0054 00
REPLACE DATA PLATE
1.
Remove four drive screws (7).
2.
Locate new data plate (8) in same area. Using plate as a template, drill four mounting holes 3/64 to 1/16 inch (1.2 to
1.6 mm) diameter.
3.
Install four new drive screws (7).
REPAIR ENGINE AND TRANSMISSION STAND BY WELDING
1.
Weld in accordance with TC 9-237 using gas tungsten-arc welding (GTAW) process, shielded metal-arc welding
(SMAW) process, or gas metal-arc welding (GMAW) process.
2.
Material: bar and plate – hot rolled carbon steel AISI 1020; tubing – ASTM-A501; angle – ASTM-A36.
END OF TASK
0054 00-14
