TM 9-2350-247-34 REPAIR TRACK IDLER ARM — Continued 0032 00 Table 1. IDLER ARMS Reference Letter Point of Measurement New Part Size/Fit Wear Limit A Inside diameter of arm bore 3.185 to 3.188 * B Outside diameter of bearing 3.1885 to 3.1925 * C Outside diameter of bearing 3.8135 to 3.8175 * D Inside diameter of arm bore - inner surface 3.809 to 3.812 * A-B Fit of bearing in arm bore 0.0005T to 0.0075T C-D Fit of bearing in arm bore 0.0015T to 0.0085T E Inside diameter of outer bearing 2.7605 to 2.7765 2.778** F Outside diameter of outer spindle 2.750 to 2.752 See Note*** G Inside diameter of bearings 3.3855 to 3.4015 3.403** H Outside diameter of inner spindle surface 3.375 to 3.377 See Note*** E-F Fit of bearing on spindle 0.001L to 0.026L G-H Fit of bearing on spindle 0.000 to 0.025L I Outside diameter of outer hub spindle 1.5618 to 1.5623 1.561 J Outside diameter of inner hub spindle 2.0618 to 2.0623 2.061 K Outside diameter at track adjuster sleeve 1.495 to 1.500 1.4850 * Must be within new part dimensions. ** Measured in assembly *** A used idler spindle shall not be put back into service if the nickel plating (0.001 to 0.002 thick) is worn through. However, a used spindle can be switched to the opposite side of the carrier, which places the load on an unused plated surface. 0032 00-3