TM 9-2350-247-20-3
REPLACE TURN SIGNAL REAR WIRING HARNESS — Continued
0512 00
INSTALLATION
1.
Position rear wiring harness (1) in left taillight. Route rear harness circuit 21 and 22-460 lead (2) and 22–460 lead (3)
through left hull channel across front of fuel compartment along main wiring harness (4).
2.
Thread rear harness circuit 21 and 22-460 lead (2) and 22–460 lead (3) through right hull channel into right taillight.
3.
Insert rear harness circuit 21 lead (2) and circuit 22-460 lead (3) through two right taillight spacer plates (5). Install leads
in bushing (6). Secure bushing and two spacer plates to hole in taillight with screw (7) and nut (8).
4.
Install lead connector shell (9), sleeve (10), and new connector (11) on rear harness circuit 21 and 22-460 lead (2) and
22–460 lead (3). Connect leads at right taillight.
0512 00-3
