TM 9-2350-247-20-3
REPAIR HOIST ASSEMBLY Continued
0485 00
ADJUSTMENT
1.
Add or remove flat washers, similar to flat washer (1) between left side plate (2), right side plate (3), and suspension
frame (4) to maintain approximately 7/8 inch (22 mm) dimension between inner surfaces of left side track wheel (5) and
right side track wheel (6). Left and right side plates must be equally spaced from centerline of hoist assembly.
2.
Add or remove flat washer (1), flat washer (7), flat washer (8), and flat washer (9) as necessary to align cotter pin hole in
lock clamp suspension pin (10) and lock clamp suspension pin (11) with slots in nut (12), nut (13), nut (14), and nut (15)
to provide proper lock for nuts.
FOLLOW-THROUGH STEPS
1.
Install hoist on carrier (WP 0484 00).
END OF TASK
0485 00-14