TM 9-2350-247-20-2
REPLACE STEERING WHEEL LINKAGE (M548A3) -- Continued
0364 00
INSTALLATION
1.
Install rod end bearing (1) and jam nut (2) on connecting link (3).
2.
Install two bearings (4), spacers (5), keys (6), shaft levers (7 and 8), washers (9), and new lock nuts (10) on ends of shaft
(11). Install two screws (12) in two spacers.
NOTE
Make sure the shaft is not touching the bulkhead after tightening the two bearings.
3.
Install two bearings (4) and shaft (11) on plate. Secure with four screws (13) and washers (14). Tighten two screws (12)
to secure shaft (11) in two spacers (5) and bearings.
4.
Join connecting link (3), connecting link(15), together with two screws (16), washers (17), and new lock nuts (18).
5.
Install lever (19), on connecting link (15) with screw (20), washer (21), and new lock nut (22).
6.
Install lever (19) on transmission with screw (23), and washer (24).