TM 9-2350-247-20-2
REPLACE ROAD WHEEL SUPPORT ARM, HOUSING, BEARINGS,
0351 00
AND SEALS -- Continued
INSTALLATION
1.
If removed, install two bearings (10) in housing (6). Use remover and replacer.
WARNING
Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These
compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you
dizzy and irritate your eyes and throat.
Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes.
Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves.
NOTE
Make sure shoulders on bearings point toward center of housing.
2.
Coat threads of relief valve (12) and lubrication fitting (11) with sealing compound. Install valve and fitting in support
arm (7).
3.
Put light coat of grease on bearing surface of support arm (7) and cork-rubber face of new seal (8). Place spacer (9) and
seal, with pins facing housing, on shaft of support arm.
4.
Install support arm (7) in housing (6). Align pins on seal (8) with holes in housing.
Change 1
