TM 9-2350-247-20-2
REPLACE TRANSMISSION RANGE SELECTOR LINKAGE (M548A1)
THIS WORK PACKAGE COVERS:
Removal (page 0315 00-1).
Installation (page 0315 00-5).
INITIAL SETUP:
Maintenance Level
References
Unit
See your -10
Tools and Special Tools
General Mechanic's Tool Kit (WP 0541 00, Item 57)
Materials/Parts
Equipment Condition
Headless grooved pin
Engine stopped (see your -10)
Lock nut (4)
Carrier blocked (see your -10)
Lock nut (4)
Lock nut (7)
Center seat raised (see your -10)
Lock washer (2)
Spring pin (2)
Left center seat floor plate raised (WP 0394 00)
Personnel Required
Wiring for neutral start switch disconnected
Unit Mechanic
REMOVAL
1.
Remove lock nut (1) and screw (2) from range selector link (3) and gear selector shaft (4). Remove link from shaft.
Discard lock nut.
2.
Remove lock nut (5) and screw (6) from range selector link bearing (7) and range selector control arm (8). Separate
range selector link (3) from link boot (9). Discard lock nut.
3.
Remove lock nut (10) and screw (11) from range selector control link (12) and gear selector arm (13). Discard lock nut.
4.
Remove gear selector arm headless grooved pin (14) from gear selector arm (13) and gear selector shaft (4). Remove
arm from shaft. Discard headless grooved pin.
