TM 9-2350-247-20-2
ADJUST GENERATOR DRIVE BELTS (M548A1)
THIS WORK PACKAGE COVERS:
Adjustment (page 0241 00-1).
INITIAL SETUP:
Maintenance Level
References
See your -10
Unit
Equipment Condition
Tools and Special Tools
Engine stopped (see your -10)
General Mechanic's Tool Kit (WP 0541 00, Item 57)
Carrier blocked (see your -10)
Personnel Required
Power plant rear access covers/door removed
(see your -10)
Unit Mechanic
Battery negative lead disconnected (WP 0292 00)
ADJUSTMENT
1.
Check position of sleeve gauge marker (1) on decal (2).
2.
If sleeve gauge marker (1) is above the operating range on decal (2), loosen jam nut (3). Turn gauge nut (4) to the left
until gauge marker is in operating range.
3.
If sleeve gauge marker (1) is below operating range on decal (2), loosen jam nut (3). Turn gauge nut (4) to the right until
gauge marker is in operating range.
4.
Tighten jam nut (3) against gauge nut (4) to lock in place.
