TM 9-2350-247-20-2
REPLACE FAN DRIVE BELT IDLER ADJUSTING LINKAGE (M548A1)
THIS WORK PACKAGE COVERS:
Removal (page 0230 00-1).
Installation (page 0230 00-3).
INITIAL SETUP:
Maintenance Level
References
Unit
See your -10
Tools and Special Tools
Equipment Condition
General Mechanic's Tool Kit (WP 0541 00, Item 57)
Torque Wrench, (WP 0541 00, Item 68)
Engine stopped (see your -10)
Materials/Parts
Carrier blocked (see your -10)
Lock nut (2)
Center seat raised (see your -10)
Personnel Required
Power plant rear access door removed (see your -10)
Unit Mechanic
Fan drive belts removed (WP 0226 00)
REMOVAL
NOTE
Front and rear idler adjusting linkages are removed the same way.
1.
Remove lock nut (1), washer (2), screw (3), and idler pulley (4) from support arm (5) and rod end (6). Discard lock nut.
2.
Remove rod end (6), jam nut (7), adjusting nut (8), and spring (9) from adjusting sleeve (10).
