TM 9-2350-247-20-2
REPLACE RADIATOR AND SEAL (M548A1) -- Continued
0215 00
7.
Secure two mounts (10) to two radiator brackets (11) with eight screws (12) and two plates (13).
8.
Install two screws (14) through two mounts (10) into insert (15) to secure radiator (7) to hull.
9.
Remove lifting device from radiator.
FOLLOW-THROUGH STEPS
1.
2.
3.
4.
Install hull bottom access cover (WP 0383 00).
CAUTION
Stop engine if coolant temperature gauge indicates above 230 F (110 C). Serious damage to
engine may result.
5.
Start engine (see your -10). Run engine until coolant temperature reaches 160 -230 F (71 -110 C).
6.
Check radiator and hoses, tubes, and fittings for leaks.
7.
Stop engine (see your -10). Remove radiator cap slowly and check coolant level.
8.
Add coolant to bring level to bottom of filler neck (WP 0212 00).
9.
Install power plant rear access cover/door (see your -10).
10. Lower center seat (see your -10).
END OF TASK
0215 00-6