HOOK UP/REMOVE STE/ICE-R FOR POWERContinued

HOOK UP/REMOVE STE/ICE-R FOR POWERContinued - TM-9-2350-247-20-1_552

TM-9-2350-247-20-1 Crane (CAB) Components Recovery Vehicle Full Tracked: light Armored M578 (2360-00-439-6242) (EIC:3LA) Manual
Page Navigation
457

TM 9-2350-247-20-1 HOOK UP/REMOVE STE/ICE-R FOR POWER—Continued 0114 00 NOTE If VTM fails to display current readouts, refer to confidence test fault isolation (see TM 9-4910-571-12&P ). NOTE Intermediate test results are displayed indicating test in progress. The end result will alternately show software revision number and the PASS message. The displayed software revision number has a month (one digit), year (two digits), and the version number (zero). The software revision flashing on the display should match the software revision number on the label located on the side of the VTM. If they are different, return the STE/ICE-R set to your supervisor. 7. Perform VTM confidence check: a. Set test select switches to 66. b. Press and release test button. c. Wait for display to show 0066. d. Set test switches to 99. e. Press and release test button. f. Wait for the alternate display of the revision number and PASS message. Go to Step 9 g. If PASS is not displayed, go to STE/ICE-R confidence test fault isolation (see TM 9-4910-571-12&P ). 8. Select test 60, then press and release TEST button. 9. Enter carrier VID (03) into VTM, then press and release TEST button. 10. Select test 61, then press and release TEST button. If carrier VID (03) does not appear on VTM display, (see TM 9-4910-571-12&P ). 11. Return to troubleshooting that referred you to this task. REMOVAL 1. Pull VTM circuit breaker to OFF. 2. Remove power cable W5 from batteries and VTM. Use electrical connector pliers. 3. Stow VTM and power cable W5 in transit case. 0114 00-3/4 blank

Privacy Statement
Press Release
Contact