HOOK UP/REMOVE STE/ICE-R TEST SET FOR TEST NUMBERS 72 THRU 75

HOOK UP/REMOVE STE/ICE-R FOR STARTER CIRCUIT TESTSContinued

HOOK UP/REMOVE STE/ICE-R TEST SET FOR TEST NUMBERS 72 THRU 75Continued - TM-9-2350-247-20-1_560

TM-9-2350-247-20-1 Crane (CAB) Components Recovery Vehicle Full Tracked: light Armored M578 (2360-00-439-6242) (EIC:3LA) Manual
Page Navigation
462

TM 9-2350-247-20-1 HOOK UP/REMOVE STE/ICE-R TEST SET FOR TEST NUMBERS 72 THRU 75 0117 00 THIS WORK PACKAGE COVERS: Hook-up (page 0117 00-1). Removal (page 0117 00-3). INITIAL SETUP: Maintenance Level Unit Tools and Special Tools STE/ICE-R Test Set (WP 0541 00, Item 6) Personnel Required Unit Mechanic References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Center seat raised (see your -10) All electrical accessories turned off (see your -10) Engine at operating temperature (see your -10) Fuel off, engine must not start (see your -10) STE/ICE-R power hooked up (WP 0114 00) HOOK-UP NOTE Do not have battery charger connected when performing test numbers 72 thru 75. 1. Remove transducer cable W4 and current probe from transit case. 2. Pull VTM circuit breaker to OFF. 3. Install cable W4P1 (1) on VTM jack J3 TK (2). 4. Attach cable W4P2 (3) to current probe (4). 5. Push VTM circuit breaker to ON. 0117 00-1

Privacy Statement
Press Release
Contact