TM 9-2350-247-20-1INTRODUCTION STE/ICE–R (SIMPLIFIED TEST EQUIPMENT FOR INTERNALCOMBUSTION ENGINES-REPROGRAMMABLE) PROCEDURES—Continued0107 00When cables are connected, the large key (1) located by the white stripe (2) on the cable connector mates with large keyway(3) of connector on VTM or transducer.a. DIAGNOSTIC CNCTRASSY CABLE W1.The W1 is used to power the VTM and provide access to test points and sensorsconnected to vehicle/equipment-mounted DCA.b. TEST PROBE CABLEW2.The test probe cable for both general and special measurements. It is used formeasuring voltages, frequency, resistance and continuity, and also for the first peakseries and compression unbalance tests. W2 is divided into two color coded leads:red for E1 and black for E2. Test clips E1 and E2 of W2 attach to points on thevehicle/equipment being tested.c. IGNITION ADAPTERCABLE W3.The ignition adapter cable W3 is used in measuring dwell angle, points voltage,engine rpm and power tests. W3 is divided into two color coded leads: red for E1and black for E2.0107 00-5
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business