TM 9-2350-247-20-1
INTRODUCTION STE/ICE–R (SIMPLIFIED TEST EQUIPMENT FOR INTERNAL
COMBUSTION ENGINES-REPROGRAMMABLE) PROCEDURES—Continued
0107 00
d. CABLE CONNECTORS.
The four cable connectors on the VTM are DCA/PWR J1, transducer cable
connectors J2 TK and J3 TK, and VOLTS/OHMS J4.
• DCA/PWR connector J1 – used to connect VTM to either a vehicle
diagnostic connector with the DCA cable W1 or to a DC power source
with the power cable W5. The DC power source is usually the vehicle’s
batteries.
• Transducer cable connectors J2 TK and J3 TK – used to connect transducer
cables W4 to VTM. Power and signals are routed through these
connectors. Both connectors may be used when a test requires two
measurements to be made at the same time.
• VOLTS/OHMS connector J4 – used to connect test probe cable W2 to
VTM for voltage and resistance tests.
0107 00-3
