TM 9-2350-247-20-1
HIGH BEAM INDICATOR LIGHT MALFUNCTIONS—Continued
0051 00
BY
1. Remove main harness plug (1) from beam selector switch
jack (2).
2. Measure resistance between beam selector switch jack (2) pins D
(3) and B (4) and between pins F (5) and H (6).
3. Did multimeter read 0 ohms for both measurements?
YES
NO
BYN
1. Replace beam selector switch
(WP 0273 00).
2. Verify no faults found.
2BY
1. Install jumper wire between main harness beam selector switch
plug (1) pins D (2) and H (3).
2. Measure resistance between pins on plug (4).
3. Does multimeter read 0 ohms?
YES
NO
2BYN
1. Repair main harness circuits 519 or
519A (WP 0294 00).
2. Verify no faults found.
3BY
1. Replace high beam indicator light (WP 0258 00).
2. Verify no faults found.
0051 00-3/4 blank
