TRANS LOW OIL PRESS INDICATOR COMES ON (M548A3)

LOW PRESS ENGINE OIL INDICATOR FAILS TO GO OFF AFTER ENGINE STARTSContinued

TRANS LOW OIL PRESS INDICATOR COMES ON (M548A3)Continued - TM-9-2350-247-20-1_270

TM-9-2350-247-20-1 Crane (CAB) Components Recovery Vehicle Full Tracked: light Armored M578 (2360-00-439-6242) (EIC:3LA) Manual
Page Navigation
205

TM 9-2350-247-20-1 TRANS LOW OIL PRESS INDICATOR COMES ON (M548A3) 0047 00 INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0541 00, Item 57) Tube-pipe Fitting Kit (WP 0541 00, Item 15) Pressure Gauge Kit (WP 0541 00, Item 34) Personnel Required Unit Mechanic References See your -10 See your PMCS Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Parking brake off (see your -10) Transmission in SL (see your -10) Transmission oil level checked (see your PMCS) Power plant warm Idle speed set at 600 rpm (see your -10) Center seat raised (see your -10) T 1. Turn MASTER SWITCH ON. 2. Is TRANS LOW OIL PRESS light on? YES NO TN 1. Go to TRANS LOW OIL PRESS indicator malfunctions WP 0055 00. Y 1. Turn MASTER SWITCH OFF. 2. Remove plug (1) from lube port switch (2). 3. Remove lube port switch (2) from tee (3). 4. Install pressure tester in tee (3). 5. Start engine and run at 1500 rpm (see your -10). 6. Measure lube pressure with transmission in SL. Use 160 psi (1103 kPa) gauge. Pressure should be over 4 psi (28 kPa). 7. Does pressure tester measure less than 4 psi (28 kPa)? YES NO YN 1. Go to TRANS LOW OIL PRESS indicator malfunctions WP 0055 00. 0047 00-1

Privacy Statement
Press Release
Contact