TM 9-2350-247-10
REMOVE/INSTALL HULL BOTTOM ACCESS COVER AND DRAIN COVER
0076 00
THIS WORK PACKAGE COVERS:
Removal (page 0076 00-1).
Installation (page 0076 00-4).
INITIAL SETUP:
Maintenance Level
Operator
Tools and Special Tools
Socket Wrench Handle (WP 0082 00, Item 27)
Socket Wrench, 9/16 inch (WP 0082 00, Item 38)
Personnel Required
Soldier
Equipment Condition
Engine stopped (WP 0023 00), (WP 0024 00)
Carrier blocked (WP 0038 00)
REMOVAL
WARNING
Moving carrier can cause injury or death. Block carrier so it won’t move before removing or
installing access cover.
WARNING
Touching your bare hands or tools to the starter terminals or electrical leads when accessing
through the bottom access cover may cause death or serious injury. Do not touch any electrical
leads or terminals on the starter because there is 24 volts with over 200 amps connected directly
from the batteries.
NOTE
Hull bottom access covers for M548A1 and M548A3 are different. Both access covers are shown.
Do Step 1 for M548A1 hull bottom access covers, then go to Step 3. Do Step 2 for M548A3 hull
bottom access cover, then go to Step 3.
Drain covers for M548A1 and M548A3 are the same and are removed and installed the same
way.
0076 00-1
