REMOVE/INSTALL TRACK PAD

TM-9-2350-247-10 Hull and Related Components Recovery Vehicle Full Tracked: Light Armored M578 (2360-00-439-6242) (EIC:3LA) Manual
Page Navigation
410

TM 9-2350-247-10 REMOVE/INSTALL TRACK PAD 0061 00 THIS WORK PACKAGE COVERS: Removal (page 0061 00-1). Installation (page 0061 00-1). Replace Bumper Mounted Track Pad (page 0061 00-2). INITIAL SETUP: Maintenance Level Operator Tools and Special Tools Hammer, 2 lb (WP 0081 00, Item 24) Socket Wrench Handle (WP 0081 00, Item 27) Socket Wrench, 15/16 inch (WP 0081 00, Item 38) Personnel Required Driver Equipment Condition Carrier on level surface Engine stopped (WP 0023 00), (WP 0024 00) REMOVAL NOTE The track pad is attached by a built in stud and one nut. 1. Remove the track pad from the track shoe. Loosen nut and pry pad out of the hole in the shoe. Use socket wrench handle and 15/16 inch socket wrench. CAUTION Use care not to damage threads on stud if you expect to use pad again. 2. Loosen stuck track pad by tapping on end of stud. Use hammer. INSTALLATION 1. Install track pad on track shoe. Install nut on stud. 2. Tighten nut using socket wrench handle and 15/16 inch socket wrench. 0061 00-1

Privacy Statement
Press Release
Contact