TM 9-2350-247-10
BREAK/JOIN TRACK Continued
0059 00
4.
Tighten each track fixture an equal amount to line up track pin holes. Tap long end of drive pin punch through track pin
holes to other side of track. Use hammer. Tighten track fixture as needed to obtain 20 degree angle between shoes to be
connected. Use adjustable wrench.
WARNING
Hammering on drive pin punch or track pin may deflect particles of metal or dirt into soldiers
eyes. To prevent eye damage, protection (goggles) is necessary.
5.
From inside of track, install track pin in track pin hole. As helper aligns track pin holes with crowbar, lightly tap in track
pin. Drive track pin all the way through track. Use hammer.
0059 00-7