TM 9-2350-247-10
STOP ENGINE (M548A1) Continued
0023 00
2.
Place the transmission range selector in N position.
3.
Set the engine to run at about 1,000 rpm for 2 minutes or so.
4.
Set the engine back to idle (650700 rpm) and check the instrument panel for normal readings.
5.
Pull the fuel cut-off all the way out. The engine will stop when it has burned all the fuel in its injectors and feed lines.
(This should only take a few seconds.)
CAUTION
Always shut the engine off before you turn the MASTER SWITCH OFF. If you turn the
MASTER SWITCH OFF with the engine running, you may damage the generator or regulator.
6.
Turn off the lights, radio, and any other electrical equipment thats on. If you have a vehicle compartment heater kit
thats been running, wait for the heater to complete its cool-down and stop itself after you turn it off. The light will go
off when the heater blower stops.
0023 00-2