OPERATE TURN SIGNAL KIT

DRIVE CARRIER (M548A3) Continued - TM-9-2350-247-10_190

TM-9-2350-247-10 Hull and Related Components Recovery Vehicle Full Tracked: Light Armored M578 (2360-00-439-6242) (EIC:3LA) Manual
Page Navigation
154

TM 9-2350-247-10 OPERATE TURN SIGNAL KIT 0022 00 THIS WORK PACKAGE COVERS: Operation (page 0022 00-1). INITIAL SETUP: Maintenance Level Operator Personnel Required Driver Equipment Condition Engine started (WP 0013 00), (WP 0014 00) OPERATE TURN SIGNAL KIT NOTE Turn signal and hazard warning lights flash. Lights work only when main light switch is set to service drive or service stop light. 1. Move control lever down to signal a left turn or up to signal a right turn. 2. To use hazard warning, push hazard tab back and move control lever past right turn signal position as far as it will go. A light in the center of the control will flash with signal lights and stop lights to let you know that you’re signaling. 3. When you have completed your turn or the hazard warning is no longer required, move control lever back to neutral position by hand. END OF TASK 0022 00-1/2 blank

Privacy Statement
Press Release
Contact