TM 9-2350-261-20-2
R E P L A C E T R A N S M I S S I O N A N D L O W E R A C C E L E R A T O R
L I N K A G E
D E S C R I P T I O N
This task covers:
Remove (page 23-25).
Clean, Inspect, And Replace (page 23-26)
Install (page 23-27).
INITIAL SETUP
Tools:
General Mechanics Tool Kit (Item 30, App D)
Materials/Parts:
Grease (Item 18, App C)
Self-locking nut (7)
Key washer (2)
Personnel Required:
Unit Mechanic
Helper (H)
References:
see your -lo
Equipment Conditions:
Engine stopped/shutdown (see your 10)
Carrier blocked (see your -10)
Trim vane lowered and power plant front
access door open (see your 10)
Drivers power plant access panel removed
(page 24-25)
Hull bottom access cover removed
(page 24-32)
Air control valve removed (page 7-11)
Air cleaner housing and element removed
(page 7-7)
REMOVE
4. Remove locknut (7) and
1.
2.
3.
Rotate transmission drive shaft (1) so
mounting flanges are in vertical position.
Disconnect three wiring harness connec-
tors (2) at drivers compartment bulkhead.
Remove two screws (3), clamps (4), and wir-
ing harness (5) from transmission cross-shaft
bracket (6).
accelerator link (9) from
cross-shaft bracket (10).
screw (8). Disconnect
accelerator
Discard locknut.
GO TO NEXT PAGE
23-25