TM 9-2350-261-20-2
INSTALL
9.
10.
11.
12.
13.
14.
Install cap (1) on receptacle (2).
Place new gasket (3) and receptacle (2) on
rear bulkhead. Secure with four new
lockwashers (4) and screws (5) with chain
(6) under head of one screw.
Install ground lead (7) and cradle (8) on
hull weldnut. Secure with new lockwasher
(9) and screw (10).
Place rear main wiring harness (11) in cra-
dle (8). Secure with clip (12).
Connect receptacle lead (13) to circuit 37A
lead (14) (right receptacle) or circuit 37B
lead (14) (left receptacle).
Install rubber shield (15) on hull mount
(16). Secure with retainer strip (17) and two
screws (18).
FOLLOW-THROUGH STEPS
1. Connect battery ground leads (page 13-2).
3. Start engine. Raise and lock ramp
(see your -10).
2. Turn MASTER SWITCH ON to check that
receptacle is installed properly.
4. Stop engine (see your -10).
END OF TASK
17-10