TM 9-2350-261202
REPLACE BATTERY LEADS (M106AZ, M125A2, AND M1064 ONLY)
DESCRIPTION
This task covers:
Remove (page 13-10).
Clean, Inspect, and Repair (page 13-11).
Install (page 13-11).
INITIAL SETUP
Tools:
General
Battery
Battery
Personnel Required:
Mechanics Tool Kit (Item 30, App D)
Unit Mechanic
Terminal Cleaner (Item 13, App D)
Terminal Puller (Item 46, App D)
References:
Materials/Parts:
See your 10
Grease (Item 18, App C)
Equipment Conditions:
Sodium bicarbonate (Item 55, App C)
Engine stopped/shutdown (see your 10)
Grommet
Carrier blocked (see your 10)
Ramp lowered (see your 10)
REMOVE
1. Turn handle and pull battery drawer (1) out.
WARNING
Gas from batteries can ex-
plode and injure you. Do
not allow sparks near bat-
teries.
Battery acid can
burn or blind you. Do not
get acid on your skin or
eyes. ALWAYS disconnect ground lead
(circuit 7) first and connect it last.
NOTE
Use battery terminal puller to remove
terminal lugs and leads from battery post.
2. Remove circuit 7 lead (2) as follows:
a.
b.
Remove nut (3) and circuit 7 lead (2)
from screw (4) on terminal lugs (5).
Remove nut (6), screw (7), two washers
(S), and lead (2) from hull mount. Remove
lead and grommet (9) from battery
compartment. Discard grommet.
NOTE
Circuit 6 and 48 positive leads are
removed from terminal lugs the same way
as the circuit 7 lead.
13-10
Change 2