| |
TM 9-2350-287-34
12-3. APU GEARCASE REPAIR (continued).
c.
ASSEMBLY
1.
Install bearing (47) in housing (27) bore.
2.
Install bearing (46), gear sprocket (24), and new seal (43) in bearing retainer (44).
3.
4.
5.
Apply sealant adhesive to gasket (45). Install new gasket
(45) on bearing retainer (44), and install bearing retainer
(44) in housing (27).
Apply sealant adhesive to threads of screws (42).
Secure bearing retainer (44) with four screws (42).
Repeat steps 1-4 for opposite side of housing (27).
NOTE
Perform step 6 only if stud was removed.
Install previously removed studs (38) in housing
(27).
6.
Sealant adhesive can burn easily, can give off harmful vapors, and is harmful to skin
and clothing. To avoid injury or death, keep adhesive away from open fire and use in
a weii-ventilated area. if adhesive gets on skin or clothing, wash immediately with
soap and water.
Sealant adhesive can burn
easily, can give off harmful
vapors, and is harmful to skin
and clothing. To avoid injury
or death, keep adhesive away
from open fire and use in a
weil-ventilated area. if
adhesive gets on skin or
clothing, wash immediately
with soap and water.
7.
Apply sealant adhesive to threads of screws (41).
Install adapter (39) in housing (27) and secure
with four screws (41) and new Iockwashers (40).
12-11
|