| |
TM 9-2350-287-34
9-3. ENGINE COMPARTMENT BULKHEAD INSULATION AND SHIELDS REPLACEMENT
(continued).
N O T E
12.
Perform step 12 only if insulation is torn, ripped, or missing. Shield (3) and insulation
(34, 35, and 36) are shown.
Pry off and discard damaged insulation (34, 35, and 36).
b.
INSTALLATION
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles
and gloves, and use only in a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT breath, vapors. DO NOT use near open flame or excessive heat.
NOTE
Perform steps 1 through 3 only if insulation or shield is new.
1.
Using dry cleaning solvent, clean and dry seal channel and insulation mounting surfaces, Make sure to
remove all seal and insulation particles.
WARNING
Adhesive causes Immediate bonding on contact with eyes, skin, or clothing and also
gives off harmful vapors. To avoid Injury or death, wear protective goggles, keep away
from open fire, and use in a well-ventilated area. If adhesive gets in your eyes, try to
keep them open, flush with water for 15 minutes, and get medical attention.
2.
Apply adhesive to new insulation (34, 35, and 36).
3.
Install insulation (34, 35, and 36) on shield (3).
9-10
|