|
| |
TM 9-2350-287-34
CHAPTER 9
BODY, CAB, HOOD, AND HULL MAINTENANCE
Paragraph
Page
Number
Paragraph Title
Number
9-1
General ............................................................................................................................................ 9-1
9-2
Upper Rear Door Small Doors and Hinge Replacement .................................................................... 9-1
9-3
Engine Compartment Bulkhead Insulation and Shields Replacement ................................................ 9-8
9-4
Projectile Rack Section Repair ......................................................................................................... 9-13
9-5
Cargo Tie Downs and Net Assemblies Repair .................................................................................. 9-23
9-6
Canister Compartment Restraint Bar Assemblies Repair .................................................................. 9-24
9-1. GENERAL.
This chapter describes and illustrates maintenance procedures for body, cab, hood, and hull components, which consist of
upper rear door small doors and hinges, engine compartment bulkhead insulation and shields, and projectile rack sections.
9-2. UPPER REAR DOOR SMALL DOORS AND HINGE REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment:
Cotter pin (2) (Item 6.1, Appendix H)
Electric disc sander (Item 13, Appendix D)
Lockwasher (4) (Item 57, Appendix H)
Electric drill (Item 14, Appendix D)
Seal (Item 112, Appendix H)
General mechanics tool kit (Item 19,
Seal (Item 113, Appendix H)
Appendix D)
Seal (left door) (Item 114, Appendix H)
Screw extractor set (Item 34, Appendix D)
Seal (right door) (Item 115, Appendix H)
Thread cutting die and tap set
Thread insert (4) (Item 132, Appendix H)
(Item 41, Appendix D)
Torch set (Item 42, Appendix D)
References:
Twist drill set (Item 46, Appendix D)
TC 9-237
Materials/Parts:
Equipment Conditions:
Adhesive (Item 2, Appendix B)
Upper rear door removed (refer to
Dry-cleaning solvent (Item 9, Appendix B)
TM 9-2350-287-20-2).
Change 1 9-1
|
