|
| |
TM 9-2350-287-34
7-2. FINAL DRIVE ASSEMBLY REPAIR (continued).
14.
15.
16.
17.
18.
19.
20.
21.
Using arbor press, install two bearings (12) on input splined gearshaft (13).
Install input splined gearshaft (13) in housing (5).
Install three pins (28) in housing (5).
CAUTION
Make sure input splined gearshaft and bearings are centered when installing cover.
Failure to do so may result [n damage to assembly.
Install new gasket (14) and housing cover (6) on housing (5) with seven new Iockwashers (17) and seven
screws (16). Torque screws between 75 and 80 ft-lb (101 and 108 N•m).
Install two plugs (15) in housing cover (6).
Install new gasket (8) and access cover (9) on housing cover (6) with 12 new Iockwashers (10) and screws
(11). Torque screws between 35 and 40 ft-lb (47 and 54 N•m).
WARNING
Sealing compounds can burn easily, can give off harmful vapors, and are harmful to
skin and clothing. To avoid injury or death, keep away from open flame and use in a
weil-ventilated area. If sealing compound gets on skin or clothing, wash immediately
with soap and water.
Coat outside diameter of seal (7) with sealing compound, and install seal (7) in housing cover (6).
With the aid of an assistant, remove housing (5) from final drive workstand.
7-8
|
