|
| |
TM 9-2350-287-34
6-3. STE/lCE RESISTOR BOX REPAIR.
This Task Covers:
a. Disassembly
b. Inspection
c. Assembly
Initial Setup:
Tools/Test Equipment:
• Lockwasher (4) (Item 51, Appendix H)
• General mechanic’s tool kit (Item 19,
• Lockwasher (4) (Item 52, Appendix H)
Appendix D)
• Lockwasher (4) (Item 54, Appendix H)
Materials/Parts:
Equipment Conditions:
• Gasket (Item 19, Appendix H)
• STE/lCE resistor box placed on clean work surface.
a.
1.
2.
3.
4.
5.
6.
7.
b.
1.
DISASSEMBLY
Remove four screws (3) from four retainers (2), and unhook four retainers (2) securing cover (4) to box housing
(1).
Remove cover (4) from box housing (1).
Tag 12 terminal leads (13). Remove eight terminal screws (10) and 12 terminal leads (13) from terminal board
(15).
Remove four screws (17), washers (22), Iockwashers (23), and nuts (24) from STE/lCE resistor box wiring
harness (16). Remove gasket (18) and STE/lCE resistor box wiring harness (16) from box housing (1).
Discard lockwashers and gasket.
Remove eight terminal screws (10), three bus connectors (11 ), five terminal lugs (1 2), and three fixed resistors
(9) from terminal board (15).
Remove four screws (7) and Iockwashers (6) securing panel (5) to box housing (1). Discard Iockwashers.
Remove panel (5), with terminal board (15), from box housing (1).
Remove four screws (14), washers (19), Iockwashers (20), and nuts (21) from terminal board (15). Remove
terminal board (15) and marker strip (8) from panel (5). Discard Iockwashers.
INSPECTION
Inspect cover (4) and box housing (1) for cracks, bends, breaks, or missing seal. Replace cover and box
housing if either is defective.
6 - 1 2
|
