|
| |
TM 9-2350-287-20-2
17-18. CONVEYOR TOGGLE CLAMP AND TUBE ASSEMBLY REPAIR (continued).
c.
1.
2.
d.
1.
2.
3.
4.
5.
e.
1.
2.
3.
4.
CLEANING AND INSPECTION
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles
and gloves and use only in a well-ventilated area. Avoid contact with skin, eyes, and
clothes and DO NOT breathe vapors. DO NOT use near open flames or excessive heat.
Clean all metal parts with drycleaning solvent.
Inspect all parts for cracks, bends, or breaks. Replace any damage parts.
ASSEMBLY
Install jam nut (16) on tube assembly (2).
Tighten jam nut (16) to ends of threaded
portion of tube assembly (2).
Install rod end (17) on tube assembly (2).
Install brace (19) and clevis (18) on rod end
(17) with screw (21) and washer (20).
Install clevis (15) on toggle clamp (6).
Install hook (3) on clevis (15) with screw
(14), new Iockwasher (12), washer (13),
and nut (11).
INSTALLATION
Install tube assembly (2), new Iockwasher
(9), washer (8), and screw (10) on takeup
end-section assembly (7).
Install toggle clamp (6) and six screws (4)
on conveyor center section (1).
Install hook (3) in tube assembly
Lower toggle clamp handle (5).
(2).
17-45
|
