|
| |
17-16. ROD ENDS AND LATCH REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment:
l Lockwasher (2) (Item 196, Appendix H)
l General mechanic’s tool kit (Item 24,
Appendix l)
Equipment Conditions:
l Vehicle parked on level ground (refer to
Materials/Parts:
TM 9-2350-287-10).
l Lockwasher (2) (Item 164, Appendix H)
l Conveyor deployed (refer to TM 9-2350-287-10).
l Lockwasher (4) (Item 165, Appendix H)
a.
1.
2.
3.
4.
5.
6.
REMOVAL
Remove nut (13) from each rod end
(11 ) located on each side of conveyor
takeup-end section assembly (1), and
back off two nuts (12) on two rod ends
(11).
Remove four screws (6), Iockwashers
(5), and washers (4) and two flanged
bearings (3) from takeup-end section
assembly (1). Discard Iockwashers.
Remove two nuts (10), Iockwashers
(9), washers (8), screws (7), and rod
ends (11) from two takeup plates (2).
Discard Iockwashers.
Remove two nuts (12) from two rod
ends (11).
Remove clip (16), pin (21), and rubber
latch (14) from bracket (15).
Remove two screws (20), Iockwashers
(19), and washers (18) and bracket
(15) from takeup-end section
assembly (1). Discard Iockwashers.
17-40
TM 9-2350-287-20-2
|
