|
| |
TM 9-2350-287-20-2
17-13. CONVEYOR HINGE ASSEMBLY REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment:
l Conveyor wiring harness removed
l General mechanic's tool kit (Item 24,
(para 7-70).
Appendix l)
l Conveyor support removed (for conveyor
takeup-end section hinges only) (para 17-4).
Materials/Parts:
l Lockwasher (6) (Item 164, Appendix H)
Equipment Conditions:
l Vehicle parked on level ground (refer to
TM 9-2350-287-10).
WARNING
Do not remove more than one conveyor hinge assembly at a time. Conveyor could
collapse. Do not operate conveyor with hinge removed. Failure to follow this warning
may result in injury to personnel.
a.
REMOVAL
NOTE
Perform step 1 for conveyor takeup-end section hinges only.
1.
Remove nut (14) and washer (13) from hinge pin (12).
2.
Remove six nuts (9), Iockwashers (8), washers (7), and screws (4) from conveyor assembly (3). Discard
lockwashers.
NOTE
For correct installation, record the number and location of shims.
3.
Remove shims (2) and conveyor hinge assembly (1) from conveyor assembly (3).
4.
Loosen setscrew (10) inhinge half(11), drive out hinge pin (6 or 12), and separate hinge halves (5 and 11).
b.
lNSTALLATION
1.
Join hinge halves (5 and 11), then drive in hinge-pin (6 or 12) through hinge halves (5 and 11) and tighten
setscrew (10) in hinge half (11).
17-30
|
