|
| |
TM 9-2360-287-20-2
17-11. CONVEYOR CENTER SECTION ASSEMBLY REPAIR.
This Task Covers:
a. Removal
b. Installation
lnitial Setup:
Tools/Test Equipment:
Equipment Conditions:
l General mechanic’s tool kit (Item 24,
l Vehicle parked on level ground (refer to
Appendix l)
TM 9-2350-287-10).
l Conveyor assembly removed (para 17-6).
Materials/Parts:
l Conveyor chain assembly removed
l Lockwasher (12) (Item 164, Appendix H)
(para 17-17).
a.
REMOVAL
1.
Remove 12 nuts (9), Iockwashers (8), washers (7), and screws (5) from two hinge halves (6). Discard
lockwashers.
WARNING
Be sure to support center section when hardware is removed and toggle clamps are
raised. Failure to follow this warning may result in injury to personnel.
2.
Raise two toggle clamps (1) to release tension on two tube assemblies (3), and remove two hooks (2) from
two tube assemblies (3).
17-26
|
