| |
TM 9-2350-287-20-2
11-3. TORSION BAR ANCHOR REPLACEMENT (continued).
5.
Remove lockwire (10) from two screws (11). Discard lockwire.
6.
Remove two screws (11), four washers (12), and torsion bar anchor (13) from hull.
b.
INSTALLATION
NOTE
· To install torsion bar anchors at positions 1, 2, 4, 5, and 6, perform steps 1
through 5.
· To install torsion bar anchors at position 7, perform steps 1 through 4, 6, and 7.
1.
Position torsion bar anchor (13) in place on torsion bar anchor cavity in hull and secure with two screws (11) and
four washers (12).
2.
Torque two screws (11) between 275 and 300 ft-lb (373 and 407 N
m).
3.
Secure two screws (11 ) to each other with new lockwire (10).
WARNING
Sealers can burn easily, can give off harmful vapors, and are harmful to skin and
clothing. To avoid injury or death, keep away from open flame and use in a well-
ventilated area. If sealer gets on skin or clothing, wash immediately with soap and
water.
Change 1 11-6
|