|
| |
TM 9-2350-287-20-2
17-1. GENERAL.
This chapter illustrates and describes procedures for the hydraulic and fluid systems, which consist of the conveyor
assembly, hydraulic reservoir, hydraulic pump, suction and return lines, selector valve, control panel assembly, upper rear
door actuator, and conveyor hydraulic hoses and fittings.
17-2. CONVEYOR SUPPORT SLINGS REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment:
Conveyor deployed (refer to
General mechanic's tool kit (Item 24,
TM 9-2350-287-10).
Appendix I)
Upper rear door lowered to 45-degree
position (refer to TM 9-2350-287-10).
Equipment Conditions:
Vehicle parked on level ground (refer
to TM 9-2350-287-10).
a.
REMOVAL
WARNING
Make sure conveyor is supported by
blocks or support stands before
attempting
to
remove
support
slings.
Failure
to
follow
this
warning may result in death or injury
to personnel.
1.
Remove locking pin (2) from each of two pins
(1).
2.
Release upper end of each of two conveyor
support sling assemblies (4) by removing pin
(1) from each of two door brackets (3).
b.
INSTALLATION
1.
Install pin (1) in each of two door brackets (3)
holding upper end of each of two sling
assemblies (4).
2.
Install locking pin (2) in each of two pins (1).
FOLLOW-ON MAINTENANCE:
Stow conveyor (refer to TM 9-2350-287-10).
Close upper rear door (refer to TM 9-2350-287-10).
Change 1 17-2
|
