|
| |
TM 9-2350-287-20-2
16-5. PERSONNEL HEATER OUTLET HOSE, TEE ASSEMBLY, AND CONTROLS REPAIR
(continued).
5.
Loosen hose clamp (6) and remove hose (5) from tee assembly (13).
6.
Loosen hose clamp (15) and remove tee assembly (13) from duct (18).
7.
Remove cotter pin (3), washer (4), and rod (2) from tee assembly (13). Discard cotter pin.
8.
Remove screw (9), nut (12), Iockwasher (11), and chain (10) from cap (7). Discard Iockwasher.
9,
Loosen hose clamp (19) and remove hose (5) from heater duct (20).
b.
DISASSEMBLY
1.
Remove two screws (25) and Iockwashers (24) and baffle (23) from tee assembly (13). Discard Iockwashers.
2.
Loosen setscrew (21) and remove arm (22) from shaft (26).
3.
Slide shaft (26) out of tee assembly (13).
c.
CLEANING AND INSPECTION
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles
and gloves, and use only in a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open flame or excessive heat.
1.
Clean all metal parts with drycleaning
solvent.
2.
Inspect all parts for cracks, bends, or
breaks. Replace any damaged parts.
d.
ASSEMBLY
1.
Position shaft (26) in place through tee
assembly (13).
2.
Install arm (22) on shaft (26) and secure
with setscrew (21).
3.
Position baffle (23) on shaft (26) in tee
assembly (13). Secure baffle (23) to
shaft (26) with two screws (25) and new
Iockwashers (24).
16-9
|
