|
| |
TM 9-2350-287-20-2
15-62. DRIVER’S SEAT REPAIR (continued).
15.
16.
e.
1.
2.
3.
Lightly coat threads of two screws (16) with sealing compound. Position vertical guide (14) on driver's seat
support base (15). Position driver’s seat support base (15) on bottom of vertical support (5) and secure with
two screws (16).
WARNING
Do not trim ends of safety belt. If safety belt has insufficient length when installed, belt
could slip instead of holding. Failure to comply with this warning could cause injury
to personnel.
Thread ends of safety belt (8) through left and right belt slides (9) and seat handle (10), then secure in slides
(9).
INSTALLATION
WARNING
Sealing compound can burn easily, can give off harmful vapors, and is harmful to skin
and clothing. To avoid injury or death, keep away from open fire and use in a well-
ventilated area. If sealing compound gets on skin or clothing, wash immediately with
soap and water.
Lightly coat threads of two screws (2) and screws (4) with sealing compound.
With assistant, position vertical support (5) place in vehicle.
Secure vertical support (5) with two screws (2), washers (1), and screws (4).
15-154
|
