|
| |
TM 9-2350-287-20-2
15-43. AFES FlRE EXTINGUISHER BOX ASSEMBLY REPAIR (continued).
b.
1.
2.
3.
4.
5.
6.
7.
c.
1.
2.
3.
4.
5.
DISASSEMBLY
Open AFES fire extinguisher box assembly door (9).
Remove cotter pin (5) from nut (6). Discard cotter pin.
Remove nut (6), washer (7), latch plate (8), and door handle (1 O) from AFES fire extinguisher box assembly
door (9).
Close AFES fire extinguisher box assembly door (9).
Remove four self-locking nuts (11 ) and washers (12) from upper and lower hinge pins (1 4). Discard self-
locking nuts.
CAUTION
When removing hinge pins, tap them only slightiy to avoid damaging their threads.
Remove two hinge pins (14) and washers (13) from AFES fire extinguisher box assembly (4) and door (9).
With assistant, remove AFES fire extinguisher box assembly door (9) from AFES fire extinguisher box
assembly (4).
CLEANiNG AND inspection
WARNING
Drycleaning solvent P-D-680 is toxic and
flammable. Always wear protective goggles
and gloves, and use only in a weii-ventilated
area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO
NOT use near open flame or excessive
heat
any damaged parts.
inspect seal (15) for rips, tears, or flat spots. If
damaged, do steps 4 through 7.
Remove damaged seal (15) from AFES fire
extinguisher box assembly (4). Discard seal.
Clean dirt and adhesive from seal mounting surface
on AFES fire extinguisher box assembly (4) with
drycleaning solvent and rag.
15-105
Clean all metal parts of AFES fire extinguisher box.
assembly (4), mounting surfaces, and rear wall of
vehicle hull with drycleaning solvent and rag.
Inspect all metal parts of AFES fire extinguisher box
assembly (4) cracks bends, and breaks. Replace
|
