|
| |
TM 9-2350-287-20-2
15-32. UPPER REAR DOOR SEALS REPLACEMENT (continued).
b.
INSTALLATION
CAUTION
Adhesive coating should not exceed 1/4 inch (6 mm). Excessive amount of adhesive
will cause seal lip to adhere to seal channel outer wall, destroying seal’s effectiveness.
Sealing compounds can burn easily, can give off harmful vapors, and are harmful to
skin and clothing. To avoid injury or death, keep away from open fire and use In a well-
ventilated area. If sealing compound gets on skin or clothing, wash immediately with
soap and water.
1.
Apply thin coating of adhesive to seal (3) and channel (2) in upper rear door (l). Allow adhesive to dry until
tacky.
NOTE
To obtain maximum sealing results, do not stretch or bunch seals during installation.
2.
Install seal (3) in channel (2) of upper rear door (1), with upper lip of seal (3) facing edge of upper rear door
(l).
3.
Install seal (6) and retainer (5) on upper rear door (1) with three screws (4).
15-80
|
