|
| |
TM 9-2350-287-20-2
15-29. CANISTER DOORS AND PERSONNEL SIDE DOOR LATCHES AND BUMPER
ASSEMBLIES REPAIR.
This Task Covers:
a. Removal
b. Installation
c. Cleaning and lnspection
d. Assembly
e. Installation
Initial Setup:
Tools/Test Equipment:
• Lockwasher (12) (item 160, Appendix H)
• General mechanic’s tool kit (Item 24,
• Lockwasher (18) (Item 164, Appendix H)
Appendix i)
Equipment Conditions:
Materials/Parts:
• Vehicle parked on Ievel ground (refer to
• Drycleaning solvent (Item 28, Appendix D)
TM 9-2350-287-10).
• Cotter pin (3) (Item 18, Appendix H)
a.
1.
2.
b.
1.
2.
3.
4.
REMOVAL
•
•
NOTE
Left and right canister and personnel side door latches and bumper assemblies are
replaced the same way.
For proper installation of personnel side door hold-open latch and bumper assembly,
record number and thickness of shims.
Remove four screws (15) and iockwashers (14), latch assembly (16), and shims (17) from hull. Discard
Iockwashers.
Remove two screws (6) and iockwashers (5), bumper assembly (2), and shims (18) from hull. Discard
Iockwashers
DISASSEMBLY
Remove cotter pin (3), straight pin (1), and bumper (4) from bumper assembly (2). Discard cotter pin.
Hold pin (12), and remove ball (7) from pin (12).
Remove four screws (8) and Iockwashers (9) and plate (1 O) from latch assembly (16). Discard Iockwashers.
Remove spring (11), pin (12), and grease fitting (13) from latch assembly (16).
15-66
|
