| |
TM 9-2350-287-20-2
15-14. BATTERY ACCESS DOORS REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment:
• Self-locking nut (2) (Item 328, Appendix H)
• General mechanic’s tool kit (Item 24,
Appendix I)
Equipment Conditions:
• Vehicle parked on level
Materials/Parts:
TM 9-2350-287-10).
• Self-locking nut (4) (Item 327, Appendix H)
ground (refer to
a.
REMOVAL
1.
Loosen handle (6) on each of two battery access doors
(l).
2.
Remove four screws (4), washers (3), and self-locking
nuts (2) from four hinges (5) and each of two access
doors (1). Discard self-locking nuts.
3.
Remove two access doors (1) from vehicle.
NOTE
Perform step 4 only if handles
damaged.
4.
b.
1.
2.
3.
are
Remove screw (7), self-locking nut (9), handle (6), and
stud (8) from each of two access doors (1). Discard self-
Iocking nuts.
INSTALLATION
NOTE
Perform step 1 only if handles were
removed.
Install stud (8) and handle (6) on each of two access
doors (1) with screw (7) and new self-locking nut (9).
Install two access doors (1) on vehicle.
Secure two access doors (1) on four hinges (5) with four
screws (4), washers (3), and new self-locking nuts (2).
4.
Tighten handle (6) on each of two access doors (l).
FOLLOW-ON MAINTENANCE:
•None
15-29
|