| |
15-13. TRANSMISSION ACCESS DOORS AND BATTERY ACCESS DOORS SEAL
REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment:
• General mechanics tool kit (Item 24,
Appendix I)
Materials/Parts:
• Adhesive, rubber (Item 5, Appendix D)
• Drycleaning solvent (Item 28, Appendix D)
• Rag (Item 56, Appendix D)
• Seal (for right transmission access door)
(Item 262, Appendix H)
• Seal (for left transmission access door)
(Item 263, Appendix H)
• Seal (for battery access doors) (Item 266,
Appendix H)
Equipment Conditions:
• Vehicle parked on level ground (refer to
TM 9-2350-287-10).
• Appropriate access door opened (refer to
TM 9-2350-287-10).
a.
1.
2.
b.
1.
2.
3.
REMOVAL
Scrape seal (1) from channel (2) on access door (3).
Discard seal (l).
WARNING
Drycleaning solvent P-D-680 is toxic and flammable.
Always wear protective goggles and gloves, and
use only in a well-ventilated area. Avoid contact
with skin, eyes, and clothes, and DO NOT use near
open flame or excessive heat.
Clean channel (2) with drycleaning solvent to remove all
adhesive and seal residue. Wipe dry with clean rags.
INSTALLATION
Apply adhesive to bottom of channel (2) and new seal (1).
Allow to dry until tacky.
Install seal (1) at middle of hinge end of door (3).
Press seal (1) into channel (2) around door (3) until ends of
seal (1) meet. Trim ends if necessary to make a smooth,
tight joint.
FOLLOW-ON MAINTENANCE:
•Close appropriate access door (refer to
TM 9-2350-287-10).
15-28
TM 9-2350-287-20-2
|