TM 9-2350-287-20-1
7-71. APU CONTROL BOX TO APU VOLTAGE REGULATOR CABLE ASSEMBLY (12330248)
REPAIR (continued).
b.
1.
2.
3.
c.
1.
2.
d.
1.
2.
3.
4.
5.
DISASSEMBLY
NOTE
Remove electrical insulation tape from section of wiring harness to be disassembled.
Remove section of electrical tape from harness.
Separate and isolate wiring harness branches.
Disassemble each wiring harness branch and replace defective wires.
ASSEMBLY
Reassemble wiring harness branches.
Regroup wiring branches and secure with electrical insulation tape.
INSTALLATION
Install wiring harness (15) on vehicle.
Connect APU control box power feed 419 (39) to wiring harness 12330252 connector.
Install ground terminal (41 ), two new Iockwashers (42) and screw (40).
Install four retaining straps (34), washers (33), new Iockwashers (32), and screws (31).
Install two harness guards (35) and seven washers (38), new Iockwashers (37), and screws (38) on vehicle.
7-218
