7-68. FRONT NATO INTERVEHICULAR SLAVE CONNECTOR GROUND LEAD (12332678) REPLACEMENT

FOLLOW-ON MAINTENANCE - TM-9-2350-287-20-1_903

FRONT NATO INTERVEHICULAR SLAVE CONNECTOR GROUND LEAD (12332678) REPLACEMENT (continued)

TM-9-2350-287-20-1 Carrier Ammunition Tracked M992A21 (2350-01-352-3021) EIC:AE6 Manual
Page Navigation
876

TM 9-2350-287-20-1 7-68. FRONT NATO INTERVEHICULAR SLAVE CONNECTOR GROUND LEAD (12332678) REPLACEMENT. This Task Covers: a. Removal b. Installation Initial Setup: Tools/Test Equipment: Equipment Conditions: General mechanic’s tool kit (Item 24, Vehicle parked on level ground (refer to Appendix I) TM 9-2350-287-10). MASTER switch set to OFF (refer to Materials/Parts: TM 9-2350-287-10). LockWasher (2) (Item 138, Appendix H) Battery ground cables disconnected (para 7-41). LockWasher (Item 164, Appendix H) APU control box removed (para 7-22). a. REMOVAL Left front and left rear NATO slave connector ground cables are removed and installed in the same manner. 1. Remove screw (6) and two Iockwashers (7) from bulkhead, and disconnect gound lead 12332678 (5) from bulkhead ground mount. Discard Iockwashers. 2. Pull back rubber boot (1) and remove screw (3), Iockwasher (4), and ground lead 12332678 (5) from NATO slave receptacle (2). Discard Iockwasher. b. INSTALLATION 1. Install ground lead 12332678 (5) on NATO slave receptacle (2) using new Iockwasher (4) and screw (3). 2. Install ground lead 12332678 (5) on bulkhead ground mount using two new Iockwashers (7) and screw (6). 7-206 NOTE

Privacy Statement
Press Release
Contact